Openbullet is not running and even localhost:5000 is closed but still very high cpu usage with error showing in cmd

[Govind441]

I get this error too in the cmd.

[Swirlon]

Every configs is stopped but still openbullet using high cpu?

If you got a lot of tochecks then it’s writing them to the database so it will take a while until it finishes writing them all. Maybe try a filesystem output instead of database and see if it’s better.

[Swirlon]

I think the second error happens only when OpenBullet stays IDLE for a long time. I haven’t seen it happen in other cases. Just close the console, if you aren’t using it.

[Govind441]

I tried filesystem output and no to checks at all.

[Swirlon]

Just end the task from Task Manager. I guess only Ruri can answer to this.

[Govind441]

I also get a error in http://localhost:5000/ at the bottom in red mark and have to reload it to make it work. don’t know why it does that

[Swirlon]

Can you show the error please?

[Govind441]

I didn’t capture it and forget what it was

[Swirlon]

What I’d suggest you is to not interrupt hard tasks in the middle of the work, else you’ll have to wait for it to respond, and reduce the CPU usage. Else you can just restart OpenBullet and start over. More reliable.

[Govind441]

it also froze in the middle of the checking and when I abort it.

[Swirlon]

Openbullet is not running and even localhost:5000 is closed but still very high cpu usage with error showing in cmd

What I’d suggest you is to not interrupt hard tasks in the middle of the work, else you’ll have to wait for it to respond, and reduce the CPU usage. Else you can just restart OpenBullet and start over. More reliable.