[Executing block Keycheck] Value was either too large or too small for an Int32

I did not find a suggestion subforum, so I will do it here.

Would it be possible to increase the keycheck to int64?

For example right now i capture something that is in bytes like this: 144263947747 (144GB)

And in the keycheck i need to make a decision if my parsed variable is greater or lower than a specific number.
However, since my variable is in bytes, the number is to high for Int32.
I think that problem could occure more often than you think since alot of websites are giving you values that are in bytes, so a change to Int64 would make sense in my opinion.

1 Like

It will take a lot of time and effort to add a new supported variable type, it’s definitely something that will happen eventually but I’m not going to do this immediately. Please open an issue on github. In the meantime use a simple C# snippet as a replacement for the keycheck.